Cleaning solvents are used heavily among industries dealing with parts or equipment. Automotive refinishing businesses apply solutions to strip all grime and dirt off of parts before repainting. The environment has been one of the largest concerns when using strong chemicals. They release toxin s into the air or soil if not disposed of properly.
Worker safety is another concern due to the chemicals entering the skin or being inhaled. A worker could experience skin irritation when in direct contact with solvents or develop internal health problems from vapor inhalation. These concerns have led to the development of green or eco-friendly cleaners. Degreasers are a necessity for many industrial processes and make using newer products even safer. Green degreasers have been designed to provide the same results without the extensive risks accompanying common hazardous cleaners.
How Does an Industrial Degreaser Fit Types Of Service Organizations Into the Motor Cleaning Process?
An industrial degreaser must be used any time an engine or other automotive part is painted. Buildup prevents the paint from adhering to the metal and from being applied evenly. Dried paint will flake off if cleaning is not performed prior to painting. Engine degreasing is not done all at once. It is a multi-step process where degreasing is performed more than once for a complete clean. The first application involves the entire engine so cleaning can be done on the warm parts. Parts are then removed and the engine is cleaned again. After degreasing has been completed, paint can be applied to the engine’s metal surface.
Run the engine until it is warm before applying the industrial degreaser to necessary parts. A plastic bag secured by tape should be used to cover the air intake duct and the distributor cap. This prevents water from getting into the intake opening. The intake is a hose with one end entirely open or covered with a screen.
A distributor cap consists of thick rubber wires leading to each spark plug. It will consist of heavy plastic, have a round shape, and be made up of five to nine wires depending on the type of motor. Any part that could suffer Mechanical Industrial Safety Ppt from water saturation must be covered. Use a spray degreaser to commence cleaning to make sure it does not touch hoses and wires. The chemical should be left on for around fifteen minutes to allow for grease penetration.
A wire brush may be used to loosen extensive buildup areas. Rinse the solvent using a strong stream of water such as that provided by a power washer. The engine compartment will have to be taken apart for internal cleaning. This involves many additional steps including hose detachment, wire removal, and spot cleaning.
A traditional degreaser can be dangerous if used during this process. It is performed in a more open environment where chemicals can easily flow through the air. Anyone working in the automotive industry can benefit from a green degreaser because compound release is minimal and the products …
General
